 |
Illinois Administrative Code (Last Updated: March 27, 2024) |
 |
TITLE83. PUBLIC UTILITIES |
|
PART467. ELECTRIC INTERCONNECTION OF LARGE DISTRIBUTED ENERGY RESOURCES FACILITIES |
§467.APPENDIX B. Application
-
Large Interconnection Request Application Form
(Greater than 10 MVA)
Name:
Company:
Mailing Address:
City:
State:
Zip Code:
Telephone (Primary):
(Alternate):
Facsimile Number:
E-Mail Address:
Alternative or Designated Representative Contact Information
Name:
Company:
Mailing Address:
City:
State:
Zip Code:
Telephone (Primary):
(Alternate):
Facsimile Number:
E-Mail Address:
Distributed Energy Resources Facility Information
Project Name:
Facility Address:
City:
County:
State:
Zip Code:
Electric Distribution Company (EDC) serving Facility site:
Electric Supplier (if different from EDC):
Account Number of Facility site (existing EDC customers):
Inverter Manufacturer:
Model:
Equipment Contractor (if known):
Name:
Mailing Address:
City:
State:
Zip Code:
Telephone (Primary):
(Alternate):
Facsimile Number:
E-Mail Address:
Electrical Contractor (if known):
Name:
Mailing Address:
City:
State:
Zip Code:
Telephone (Primary):
(Alternate):
Facsimile Number:
E-Mail Address:
License number:
Existing Electric Service Information for Customer Facility Where Generator Will Be Interconnected
Check here if there is no existing electric service at the site
Capacity:
(Amps)
Voltage:
(Volts)
Type of Service:
(If customer-provided) Three-Phase Transformer, Indicate Type:
Primary Winding
Secondary Winding
Transformer Size:
Impedance:
Point of Interconnection − Brief Description and Address of the Distributed Energy Resources
Location:
Intent of Generation (check all that apply):
Offset Load (Unit will operate in parallel, but will not export power to EDC)
Back-up Generation (Units that temporarily operate in parallel with the electric distribution system for more than 100 milliseconds)
Qualified Facility ("QF") under PURPA
Other, please describe:
Note: Backup units that do not operate in parallel for more than 100 milliseconds do not need an interconnection agreement.
Generator & Prime Mover Information
ENERGY SOURCE (Hydro, Wind, Solar, Process Byproduct, Biomass, Oil, Natural Gas, Coal, etc.):
ENERGY CONVERTER TYPE (Wind Turbine, Photovoltaic Cell, Fuel Cell, Steam Turbine, etc.):
NAMEPLATE CAPACITY:
kW or kVA
NUMBER OF UNITS:
TOTAL EXPORT CAPACITY:
kW or kVA
GENERATOR TYPE (Check one):
Induction Inverter Synchronous Other
Distributed Energy Resources Facility Information
Estimated Commissioning Test Date: __________________________________
Note: Provide the following information to the extent known. The EDC will contact you for additional information that may be needed after reviewing the application.
List interconnection components/systems to be used in the distributed energy resources facility.
Component/System
NRTL Providing Label & Listing
1.
2.
3.
4.
5.
Please provide copies of manufacturer brochures or technical specifications
Energy Production Equipment/Inverter Information:
Rating:
kW
Rating:
kVA
Rated Voltage:
Volts
Rated Current:
Amps
System Type Tested (Total System):
Yes
No; attach product literature
For Synchronous Machines:
Manufacturer (when available):
Model No. (when available):
Version No. (when available):
Submit copies of the Saturation Curve and the Vee Curve
Rated RPM:
Field Amperes:
at rated generator
voltage and current and
% PF over-excited
Type of Exciter:
Output Power of Exciter:
Type of Voltage Regulator:
Locked Rotor
Synchronous Speed:
RPM
Winding Connection:
Min. Operating Freq:
Generator Connection:
Direct-axis Synchronous Reactance:
(Xd)
ohms
Direct-axis Transient Reactance:
(X'd)
ohms
Direct-axis Sub-transient Reactance:
(X''d)
ohms
Negative Sequence Reactance:
ohms
Zero Sequence Reactance:
ohms
Neutral Impedance or Grounding Resister (if any):
ohms
For Induction Machines:
Manufacturer:
Model No.:
Version No.:
Locked Rotor Current:
Amps
Rotor Resistance (Rr):
ohms
Exciting Current:
Amps
Rotor Reactance (Xr):
ohms
Reactive Power Required:
Magnetizing Reactance (Xm):
ohms
VARs (No Load)
Stator Resistance (Rs):
ohms
VARs (Full Load)
Stator Reactance (Xs):
ohms
Short Circuit Reactance (X"d):
ohms
Phases:
Frame Size:
Design Letter:
Temp. Rise:
°C.
Limited Export and Non-Export Controls Information
Manufacturer:
Model Number:
Limited Export or Non-Export?
Limited Export
Non-Export
Control Type:
Reverse Power Protection
Minimum Power Protection
Relative Distributed Energy Resource Rating
Configured Power Rating
Limited Export Power Control Systems
Limited Export using mutually agreed-upon means
Directional Power Protection
Export Capacity Value:
Control Power Setting:
Control Power Time Delay (if any):
Additional Information for Inverter-Based Facilities
Inverter Information:
Manufacturer:
Model:
Type:
Rated Output:
Watts
Volts
Efficiency:
%
Power Factor:
%
Inverter UL 1741 Listed:
DC Source / Prime Mover:
Rating:
kW
Rating:
kVA
Rated Voltage:
Volts
Open Circuit Voltage (if applicable):
Volts
Rated Current:
Amps
Short Circuit Current (if applicable):
Amps
Dedicated Transformer (applicant owned):
Rating:
MVA
Voltage Ratio:
/
kV
Fixed Tap Setting:
Winding connections:
Impedance:
% based on transformer rating
Capacitor Banks:
Type:
Size:
MVAR
Other Facility Information:
One Line Diagram attached: Yes
Plot Plan attached: Yes
Battery Storage Facility Information (If Applicable)
Do the batteries share an inverter with a renewable energy system?
☐ Yes
☐ No
Does the applicant intend to have the batteries charged by the distribution grid?
☐ Yes
☐ No
System Manufacturer:
Model:
Battery Type:
Battery Charge/Discharge Rating (kW AC):
Maximum Battery Charge/Discharge Rate (kW AC per second):
Battery Energy Capacity (kWh):
Power Factor Settings Range:
Battery Storage Inverter Information
Energy System
Manufacturer:
Model:
Type: ☐ Forced ☐ Commutated
Line Commutated Rated Output
Watts:
Volts:
Efficiency:
____ %
Power Factor:
____ %
Inverter IEEE 1547 / UL 1741 Listed:
☐ Yes
☐ No
Number of Inverters:
Total Capacity:
kW
DC Source / Prime Mover:
- Rating:
kW Rating:
kVA Rated Voltage:
Volts
Open Circuit Voltage (If Applicable):
Volts
Rated Current:
Amps
Battery Operational Information
Backup – allows for partial or whole home transition to off-grid during a grid outage. ☐ Yes ☐ No
Solar Self-Powered – the battery will charge from the renewable energy source during normal operation and discharge to serve loads behind your meter. ☐ Yes ☐ No
Solar Non-Export – limits the export of energy to the grid to zero for both the battery and inverter, even if the battery system is fully charged and there is excess renewable source energy. ☐ Yes ☐ No
Time-Based Control (sometimes called time-of-use or TOU mode) – the battery charges during off-peak hours and discharges to serve onsite loads during on-peak hours. ☐ Yes ☐ No
Describe any other intended operation of the battery:
Comments or additional information:
Customer Signature
I hereby certify that all of the information provided in this Interconnection Request Application Form is true.
Applicant Signature:
Title:
Date:
An application fee must be submitted before the application can be processed. The application fee is $15,000 for all Large (>10 MVA) Distributed Energy Resources Facilities. Of the total application fee, $5,000 is nonrefundable, while the EDC shall apply the remaining $10,000 toward any subsequent studies related to this application.
EDC Acknowledgement
Receipt of the application and fee is acknowledged. This acknowledgement does not preclude the requirement to furnish additional information by the applicant if requested by the EDC when it is necessary for the EDC's review under these procedures. When this interconnection request is deemed complete by the EDC, the EDC shall notify the interconnection customer in writing.
EDC Signature:
Date:
Printed Name:
Title:
(Source: Amended at 46 Ill. Reg. 9788, effective May 26, 2022)